Search found 4 matches

by cusoak
Thu Jun 13, 2019 3:05 pm
Forum: General
Topic: New to this site
Replies: 6
Views: 3449

Re: New to this site

Before I but I have a question.
I have a shapeoko xxl made by Carbide 3D
I run Carbide motion to run the Gcode.
If your program compatible with Carbide motion.
And has the price of the soft ware changed.
Thanks Jeff
by cusoak
Sat Sep 15, 2018 9:28 am
Forum: General
Topic: New to this site
Replies: 6
Views: 3449

Re: New to this site

Ok I want to buy your program to do box joints, I want to make boxes out of 1/2"material The sides will be 4" wide and 9"tall bottom will be the same size. I need to create joints on the bottom only The top will have a rabbit on both ends and just sit on the sides. Would/ could you sh...
by cusoak
Wed Sep 12, 2018 8:08 am
Forum: General
Topic: New to this site
Replies: 6
Views: 3449

New to this site

Hi New here. Looking at this forum I see that there is not a whole lot of activity here.
I was just wondering how many copies of the software have been sold?
Jeff
by cusoak
Wed Sep 05, 2018 8:11 am
Forum: General
Topic: Box joints
Replies: 3
Views: 2129

Box joints

I am new here and am looking to buy this program. I own a Shapeoko XXL with a Dewalt router on it It will cut past the front rail far enough to cut 1.25 thick wood. It has a cutting width of 30 plus inches in width. So mounting wood to the front with some sort of a gig should not be a problem I want...