Before I but I have a question.
I have a shapeoko xxl made by Carbide 3D
I run Carbide motion to run the Gcode.
If your program compatible with Carbide motion.
And has the price of the soft ware changed.
Thanks Jeff
Search found 4 matches
- Thu Jun 13, 2019 3:05 pm
- Forum: General
- Topic: New to this site
- Replies: 6
- Views: 58979
- Sat Sep 15, 2018 9:28 am
- Forum: General
- Topic: New to this site
- Replies: 6
- Views: 58979
Re: New to this site
Ok I want to buy your program to do box joints, I want to make boxes out of 1/2"material The sides will be 4" wide and 9"tall bottom will be the same size. I need to create joints on the bottom only The top will have a rabbit on both ends and just sit on the sides. Would/ could you show me with scre...
- Wed Sep 12, 2018 8:08 am
- Forum: General
- Topic: New to this site
- Replies: 6
- Views: 58979
New to this site
Hi New here. Looking at this forum I see that there is not a whole lot of activity here.
I was just wondering how many copies of the software have been sold?
Jeff
I was just wondering how many copies of the software have been sold?
Jeff
- Wed Sep 05, 2018 8:11 am
- Forum: General
- Topic: Box joints
- Replies: 3
- Views: 32079
Box joints
I am new here and am looking to buy this program. I own a Shapeoko XXL with a Dewalt router on it It will cut past the front rail far enough to cut 1.25 thick wood. It has a cutting width of 30 plus inches in width. So mounting wood to the front with some sort of a gig should not be a problem I want...