Search found 5 matches
- Sun Oct 05, 2014 12:36 pm
- Forum: General
- Topic: JointCAM Dovetail
- Replies: 5
- Views: 40012
Re: JointCAM Dovetail
Thanks. Here are some photos of my setup along with a couple other dovetail tests. I first tried holding the material with bar clamps but it was not solid enough and I got tear out. Adding the maple bars across the material prevents any movement and made the joints much better. The recoil bars on th...
- Sat Oct 04, 2014 9:19 pm
- Forum: General
- Topic: JointCAM Dovetail
- Replies: 5
- Views: 40012
Re: JointCAM Dovetail
On the through dovetails i used a clearance of +.002 and it is still pretty tight. On half blind i needed -.002 using the same dovetail bit.
- Sat Oct 04, 2014 4:11 pm
- Forum: General
- Topic: JointCAM Dovetail
- Replies: 5
- Views: 40012
JointCAM Dovetail
Trying out different things and wanted to try and replicate the Incra double dovetail. I got close but did not think about the second dovetail being a half blind so my first cut was too deep. Finished it off with another through dovetail instead. The program is great. Now that my machine is setup an...
- Fri Oct 03, 2014 8:00 pm
- Forum: General
- Topic: Error message
- Replies: 6
- Views: 40119
Re: Error message
I sent you an email with my files and details.
- Fri Oct 03, 2014 3:59 pm
- Forum: General
- Topic: Error message
- Replies: 6
- Views: 40119
Re: Error message
I also received an error message when trying to output code after upgrading to current version. Tried a clean install (backed up my user settings first) and still got the error so I uninstalled again and went back to original version which is working fine.