G-Force CNC User Forum

Welcome to the JointCAM User Forum !!

Thank you Gerry

I just wanted to be the first person (apart from yourself) to actually post a message here.

Thanks. I was wondering if I set up the forum properly, so that it even works??

off to a good start

al

Im in
So looking forward to this forum growing. Ill try and help if and where I can just thought I would check in.
Great work too Gerry.

Cheers
Tony

Hello gentlemen,

I am a retired electrician / draftsman and I have been around computors for a long time, I am enjoying using my homemade CNC machine.

I originally came into CNC because I wanted to make better boxes in my spare time and I love doing dovetails I was crap at it until now, I have been in my shop today and have made a few attempts, I am getting there. Nothing to be proud of yet but I see the potential.

regards Neal

Hi Gerry !!

Not a lot of activity here, but....is there any way I may receive notification on what ever is posted on any topics, kind of a general notification ?
Also, is there another place (forum) where JointCam users post ?
Thks, later
Robert

From the main Board Index, if you click on General, is there a "Subscribe" option at the bottom of the page?
If so, subscribe to that and the Development section.

Then, in the User Control panel, under Board Preferences, check the email box next to the appropriate options. You can also subscribe to individual topics.

No, there isn't much traffic here at all. I think that most people just email me if they have questions.

on General, is there a "Subscribe" option at the bottom of the page?...
Kinda !!
Hidden like a !!!....it's at the bottom left, under the little ranch key @_# ...hard to tell it’s about that !!

Then, in the User Control panel, under Board Preferences, check the email box next to the appropriate options.
→ That is basically admin notification + allow user to PM !

You can also subscribe to individual topics.... not !!

No, there isn't much traffic here at all. I think that most people just email me if they have questions.
In my opinion, your to god to reply on CNCzone

Anyway, thanks for all this & more !
Later, Robert