Mortise and Tenon

General JointCAM questions and discussion
Post Reply
sawduststeve
Posts: 1
Joined: Sat Aug 06, 2016 11:17 am

Mortise and Tenon

Post by sawduststeve »

I am using 0.9.0.37 and the Mortise / Tenon option is grey. I'm assuming it is not functional yet.

Any ETA for it or is that not likely to make it?

Steve.

G-Force_Admin
Site Admin
Posts: 81
Joined: Tue Sep 23, 2014 5:10 pm

Re: Mortise and Tenon

Post by G-Force_Admin »

I've been working on it regularly for the last few months, but it's still going to be a little while. The interface is complete, after completely redoing it 3-4 times, and I'm working out the toolpaths now.
Can't give you an ETA, though.
Gerry

Post Reply