Page 1 of 1

JointCAM on X-Carve

Posted: Sat Jan 05, 2019 1:55 am
by Lexo_24
Hello, To anyone who still comes to this forum, I am new to this forum and wanted to know if anyone has successfully made Joint CAM work with an X-Carve CNC from inventables? I'm interested enough to purchase but wanted to know if it is only limited to certain CNC's? Thank You

Re: JointCAM on X-Carve

Posted: Wed Dec 21, 2022 2:39 pm
by Alvaradokid
Hi I like to know if you ever got it figured out up and running on your machine I have a similar machine that uses a very similar post-processor wondering if you got it up if you could share me your configuration settings thank you

Re: JointCAM on X-Carve

Posted: Sun Jan 15, 2023 9:13 pm
by G-Force_Admin
If you email me at support at g-forcecnc.com, I can help you setup JointCAM to work with an X Carve. I know there are a few X Carve owners using JointCAM, but will have to do a little research to get the correct info.