New Version 0.9.0.12

Questions and discussion relating to JointCAM's development.
Post Reply
G-Force_Admin
Site Admin
Posts: 81
Joined: Tue Sep 23, 2014 5:10 pm

New Version 0.9.0.12

Post by G-Force_Admin »

Version 0.9.0.12 - 10/5/14
1) Added Scrollbars to tool table (only displayed if needed)

2) Fixed immediate move to clearance plane before moving at first rapid height for through dovetails.

3) Fixed crash caused by divide by zero error if depth per pass was set to zero.

4) Fixed crash caused by no value in the feedrate scale box on configuration page.

5) Fixed possible gouge on retract for custom through dovetails.

6) Fixed installer writing tool table file to appdata\JointCAM\1.0 instead of appdata\JointCAM\1.0\Config
Gerry

Post Reply