New Version 0.9.0.14

Questions and discussion relating to JointCAM's development.
Post Reply
G-Force_Admin
Site Admin
Posts: 81
Joined: Tue Sep 23, 2014 5:10 pm

New Version 0.9.0.14

Post by G-Force_Admin »

Version 0.9.0.14 - 10/12/14

1) Added additional pass on last pin for through dovetails right pins to match left hand toolpath.

2) Fixed Clearance setting for half blind custom dovetails. Actual clearance applied was less than specified.

3) Added final move to back out of half blind custom tails, rather than lifting out and possibly damaging a backer board.
Gerry

AuS MaDDoG
Posts: 6
Joined: Fri Oct 03, 2014 6:24 am
Location: Far North Queensland Australia

Re: New Version 0.9.0.14

Post by AuS MaDDoG »

Gerry,

How do we update our software to the current versions ?

Cheers
Tony.

G-Force_Admin
Site Admin
Posts: 81
Joined: Tue Sep 23, 2014 5:10 pm

Re: New Version 0.9.0.14

Post by G-Force_Admin »

Just download it from the link I sent you with your license info and install right over the existing installation.
Gerry

AuS MaDDoG
Posts: 6
Joined: Fri Oct 03, 2014 6:24 am
Location: Far North Queensland Australia

Re: New Version 0.9.0.14

Post by AuS MaDDoG »

Thanks Gerry,

God damn If I opened my eyes and read the email lol.
All good thanks mate !!

Cheers
Tony.

Post Reply