New Version

Questions and discussion relating to JointCAM's development.
Site Admin
Posts: 74
Joined: Tue Sep 23, 2014 5:10 pm

New Version

Postby G-Force_Admin » Mon Oct 20, 2014 7:32 pm

Note: If you have not installed version, your license information will need to be re-entered. See the Announcement for version

Version - 10/20/14

2 fixes for metric users...

1) Removed comma separator on values of 1000 or greater, which produced invalid g-code coordinates (X1,100)

2) G20/G21 value was not being saved in Configuration settings file, and would always default to G20.

Note: If updating a previous version, after installation, go to Configuration, and configure the G20/G21 setting and use the Save Settings button. If this is not done, G21 will be the default setting when JointCAM is started.