Test Version 0.9.0.17 - with box joints

Questions and discussion relating to JointCAM's development.
Post Reply
G-Force_Admin
Site Admin
Posts: 81
Joined: Tue Sep 23, 2014 5:10 pm

Test Version 0.9.0.17 - with box joints

Post by G-Force_Admin »

I uploaded a development version with box joint capabilities.
They should be fully functional with one exception. There are options for A, B, and A+B boards to be machined. The A+B option will not output any code.

No manual or docs yet, but it should be self explanatory.

I haven't run any box joint code on a machine, only in simulation mode, but it all appears to be correct.
Gerry

G-Force_Admin
Site Admin
Posts: 81
Joined: Tue Sep 23, 2014 5:10 pm

Re: Test Version 0.9.0.17 - with box joints

Post by G-Force_Admin »

I've updated the manual to include some information on the box joint portion of JointCAM.

http://g-forcecnc.com/downloads/JointCA ... 0V1.03.pdf
Gerry

AuS MaDDoG
Posts: 6
Joined: Fri Oct 03, 2014 6:24 am
Location: Far North Queensland Australia

Re: Test Version 0.9.0.17 - with box joints

Post by AuS MaDDoG »

Hi Gerry,

Just updated both the manual and the software.

Cheers
Tony.

Post Reply