New Version 0.9.0.10

Questions and discussion relating to JointCAM's development.
G-Force_Admin
Site Admin
Posts: 74
Joined: Tue Sep 23, 2014 5:10 pm

New Version 0.9.0.10

Postby G-Force_Admin » Mon Sep 29, 2014 8:20 pm

Version 0.9.0.10 - 9/29/2014

1) Added ability to scale feedrate. Primarily for ShopBot users, this allows you to specify feedrate in JointCAM in inches/min, and output code in inches/second.
Enable this option by checking "Scale Feedrate Yes/No" on COnfiguration page, and enter scale factor. Use 0.1667 to convert from inches/minute to inches/second (1/60).
Configure and use "Save Settings" to add these settings to the saved settings.

2) Tool table new tool info default values were imperial. Changed to have empty boxes when tool table loads. Also fixed incorrect error messages for faulty data entry.
Gerry