feature Suggestion
Posted: Mon Dec 25, 2023 10:50 am
First, Hello, Just bought the program so this is a likely newb issue.
When cutting half blind joints could there be an option to first pass over the top of the tails to square the board (maybe even for all tail cuts). My cutoff saw obviously doesn't do it.
I now do it with a separate toolpath.
Then you could have an additional option to put a stop at the bottom end of the board, the cnc would cut the top to length(caution might get nasty) and you would get a set size length every time.
Or how are you all doing it to make a box an exact size you want
When cutting half blind joints could there be an option to first pass over the top of the tails to square the board (maybe even for all tail cuts). My cutoff saw obviously doesn't do it.
I now do it with a separate toolpath.
Then you could have an additional option to put a stop at the bottom end of the board, the cnc would cut the top to length(caution might get nasty) and you would get a set size length every time.
Or how are you all doing it to make a box an exact size you want